Paint Overspray Removal On Car Service in Brewster, NY

Rough texture to your paint? White specs of paint? We can remove that.

See Small Specs On Your Paint? Rough Texture? It’s Paint Overspray.

When you see small colored specs on your paint or feel a rough texture on the panel when you slide your hand over it, it’s due to tiny paint particles that have landed on your vehicle.

Usually this happens when you’re near a construction site or someone is painting outside and the wind carries over a very thin layer of paint particles over to your vehicle.

It’s most likely all over your vehicle; glass, paint, trim, wheels, etc… it’s not fun to see, let alone to remove it from all those surfaces. And you have to remove the overspray if you want to get a ceramic coating, paint protection film (PPF) or color changing wrap done on your vehicle.

That being said, small specs on your paint and the rough texture feeling could be something else like other types of above surface containmiments.

Don’t Do More Harm Than Good To Your Paint

Scratching and rubbing your paint vigorously with a towel, plastic razor, or brush will do nothing other than install a bunch of swirls and scratches into your paint.

We see this time and time again. It just adds more work to your vehicle because now there’s two parts that we have to address:

The first part is removing the overspray. Sometimes it’s easy, sometimes it’s very difficult. It depends on the type of paint and the surface that it’s on (i.e trim vs wheels vs paint vs glass).

Many times, even with safe removal methods, it will cause minor marring to the paint. Because of this, a light polish will be needed to remove the marring.

However, if you aggressively scratch your paint, we’ll then have to use a more intense method of paint correction to remove those heavy swirls and scratches you caused.

    1. Wheel/Tire/Wheel Well Complete Detail - cleaning the face of the wheels, wheel barrel, tires, wheel wells.

    2. Road Tar, Sap, bug, Bird Dropping - Removal of all that pesky road tar, sap, & bird dropping that can ruin your paint.

    3. Complete Exterior Wash - Removal of dirt on your vehicles paint.

    4. Decontamination - Chemical removal or embedded contaminates in your paint via iron remover & clay bar.

    5. Towel Dry & Air Blower - Getting into the tight areas where water likes to hide, we blast it out with our air blower & finish with a soft plush drying towel.

    6. Door Jamb Detail & Protection - A clean door jamb makes or breaks a vehicle.

    7. Tire Dressing - Add shine & protection on Wheel/Tire/Wheel Well from dirt & brake dust.

    8. Paint Correction (1 Step) - Machine polish removes up to 60-80% of minor scratches, paint transfer, & swirl marks on your vehicle paint finish and at the same time leaving a wax/sealant protection on the exterior surface that lasts between 4 to 6 months.

    9. Paint Protection - Spray wax, adding shine and protection up to three months.

    10. Black Trim - Semi permanent dressing & protection up to 2-year duration.

    11. Glass Cleaning - Exterior/Interior Streak free glass.

  • Price will vary based on size and condition $375 - $1500

  • Ceramic Coating 1 Year Duration: Starting $350

    Ceramic Coating 3 Year Duration: Starting $550 - $750

    Ceramic Coating 6 Year Duration: Starting: $750 - $900

    Ceramic Coating 10 Year Duration: Starting $1400 - $1800

    Paint Correction 1 step: Starting $1000 - $1150

    Paint Correction 2 step: Starting $2000 - $2600

    Head Light Restoration: $120

    Engine Cleaning: $80

    Windshield Ceramic Coating: $125

    Rim Face Ceramic Coating: $200

    Convertible Soft Top Dye + Protection: $250

    Convertible Soft Top Protection: $125

Paint Overspray Removal

Now, this service in itself is good enough to get your paint back to where it was (and sometimes, even better). That being said, if you’d like to increase the overall appearance of the vehicle, a Ceramic Coating or Paint Correction service will achieve that for you.

Paint Overspray FAQs

  • For this level of service, ideally working in a garage is best but nevertheless we can get the job done. Paint overspray removal can be very tedious based on the type of overspray. With how bad the Brewster heat gets, it makes doing the job difficult when the panels are extremely hot and the chemicals dry really fast.

  • A clay bar treatment is a great option to cleanse the paint from above surface contaminants. It’s what we do on every Paint Enhancement or Wash and Wax service. However, when it comes to overspray, it’ll need to be “pulled” off differently. You can spend more time claying but you won’t get favorable results. It’s a very tedious and time consuming process.

  • Generally speaking, yes. We can remove it from glass, wheels, fenders, trim, etc… However, that doesn’t mean we’ll be able to remove 100% of all the overspray. As always, we’ll follow the our detailing methodology. But some areas and surfaces will be more problematic than others. Especially depending on the type of paint that landed on your vehicle.

  • It might be able to remove a tiny fraction of the overspray that has landed on your vehicle, but for the most part, it won’t do much. You can try your best to work the product into the area with a towel but you’re not going to see a significant difference.

Get in touch.

If you want to schedule or you need more information, please fill out this form below. We will be with you as soon as possible. We look forward to hearing from you!